
تاريخ الفيزياء

علماء الفيزياء


الفيزياء الكلاسيكية

الميكانيك

الديناميكا الحرارية


الكهربائية والمغناطيسية

الكهربائية

المغناطيسية

الكهرومغناطيسية


علم البصريات

تاريخ علم البصريات

الضوء

مواضيع عامة في علم البصريات

الصوت


الفيزياء الحديثة


النظرية النسبية

النظرية النسبية الخاصة

النظرية النسبية العامة

مواضيع عامة في النظرية النسبية

ميكانيكا الكم

الفيزياء الذرية

الفيزياء الجزيئية


الفيزياء النووية

مواضيع عامة في الفيزياء النووية

النشاط الاشعاعي


فيزياء الحالة الصلبة

الموصلات

أشباه الموصلات

العوازل

مواضيع عامة في الفيزياء الصلبة

فيزياء الجوامد


الليزر

أنواع الليزر

بعض تطبيقات الليزر

مواضيع عامة في الليزر


علم الفلك

تاريخ وعلماء علم الفلك

الثقوب السوداء


المجموعة الشمسية

الشمس

كوكب عطارد

كوكب الزهرة

كوكب الأرض

كوكب المريخ

كوكب المشتري

كوكب زحل

كوكب أورانوس

كوكب نبتون

كوكب بلوتو

القمر

كواكب ومواضيع اخرى

مواضيع عامة في علم الفلك

النجوم

البلازما

الألكترونيات

خواص المادة


الطاقة البديلة

الطاقة الشمسية

مواضيع عامة في الطاقة البديلة

المد والجزر

فيزياء الجسيمات


الفيزياء والعلوم الأخرى

الفيزياء الكيميائية

الفيزياء الرياضية

الفيزياء الحيوية

الفيزياء العامة


مواضيع عامة في الفيزياء

تجارب فيزيائية

مصطلحات وتعاريف فيزيائية

وحدات القياس الفيزيائية

طرائف الفيزياء

مواضيع اخرى
Work Done in Overturning a Body
المؤلف:
GEORGE A. HOADLEY
المصدر:
ESSENTIALS OF PHYSICS
الجزء والصفحة:
P-86
2025-11-05
246
The work that must be done to overturn a body is a measure of its stability. When a cylinder lies upon its side, the only work necessary to overturn it is to overcome the friction between it and the surface upon which it lies, since the center of gravity moves in a horizontal line. If, however, the body is a cube, the center of gravity is raised a distance ab every time it is turned over, and the work done is just the same as would be done in lifting the cube through the height ab (Fig. 1).
Fig.1
A brick lying on a table upon its side has greater stability than one standing on end. The work necessary to overturn it in each case is expressed by the formula Work = W × ab.
In both cases shown in Fig. 1 the highest position of the center of gravity is the same, but the original heights above the table are unequal and so the product W × ab is greater in A than in B.
FIG.2
Demonstration. -Get a brass ball such as is used on the ends of curtain poles. Remove the screw, enlarge the hole, and pour in a little melted lead When the lead has cooled in position A, put the ball in any other position, as B, and since a vertical line from the center of gravity C does not fall within the base D, the ball will roll and the center of gravity will fall until it reaches the lowest possible position, when a vertical line from C will fall within the base of support, and the ball will be in a condition of stable equilibrium.
FIG. 3
The principle of this demonstration is applied in making one kind of oil cans. The ordinary form is conical (Fig. 4, А), and' if it is overturned, the oil escapes. But when the base is made in the form of a hemisphere and loaded with a little lead in the bottom (a), the can will always right itself and the oil will be retained.
FIG.4
الاكثر قراءة في الميكانيك
اخر الاخبار
اخبار العتبة العباسية المقدسة
الآخبار الصحية

قسم الشؤون الفكرية يصدر كتاباً يوثق تاريخ السدانة في العتبة العباسية المقدسة
"المهمة".. إصدار قصصي يوثّق القصص الفائزة في مسابقة فتوى الدفاع المقدسة للقصة القصيرة
(نوافذ).. إصدار أدبي يوثق القصص الفائزة في مسابقة الإمام العسكري (عليه السلام)