What experiments can be done to resolve unambiguously questions about binding and initiation rates? One of the easiest measurements to perform with RNA polymerase is quantitation of the total RNA synthesized. It is tempting to try to adapt such measurements to the determination of binding and activation rates of RNA polymerase. The execution of the experiments and the interpretation of the data are difficult, however, and many misleading experiments have been done.

Somewhat more direct measurements on the initiation of transcription are possible. Such measurements were first performed by McClure, who discovered that as RNA polymerase initiates in vitro it often goes through several cycles of abortive initiation in which a short two or three nucleotide, or sometimes longer polynucleotide is synthesized. The sequence of these abortive initiation products is the same as the 5’ end of the normal RNA transcript. RNA, like DNA, is elongated in the 5’-to-3’ direction. After one short polynucleotide is made, RNA polymerase does not come off the DNA, but it remains bound at the promoter, and another attempt is made at initiation. Additionally, two conditions lead to the exclusive synthesis of the short polynucleotides: the presence of rifamycin or the absence of one or more of the ribonucleoside triphosphates (Fig. 1). If nucleotides are omitted, those present must permit synthesis of a 5’ portion of the normal transcript. Under these conditions, a polymerase molecule bound to a promoter and in the initiation state will continuously synthesize the short, abortive initiation polynucleotides.

Fig1. Generation of abortive initiation products by provision of only the first two nucleoside triphosphates required by a promoter.

Assay of the short polynucleotides synthesized under conditions where longer polynucleotides cannot be synthesized provides a good method of assaying initiation by RNA polymerase on many promoters. The measurement is free of complexities generated by multiple initiations at a single promoter or of the difficulties in interpretation generated by the addition of inhibitors. All that is necessary is the omission of the appropriate nucleoside triphosphates. Once RNA polymerase initiates on a promoter, it begins production of short polynucleotides, but nothing else happens at this copy of the promoter.

Let us consider the possibility that the time required for RNA polymerase molecules to locate and bind to the promoters is a significant fraction of the total time required for binding and initiation. An experiment can be performed by mixing RNA polymerase, DNA containing a promoter, and two or three of the ribonucleoside triphosphates and measuring the kinetics of appearance of the short polynucleotides that signal initiation. Suppose that the same experiment is repeated but with the RNA polymerase at twice the original concentration (Fig.2). In this case the time required for RNA polymerase to find and bind to the promoter should be half as long as in the first case, but the time required for the isomerization part of the initiation process will remain the same.

Fig2. The kinetics of synthesis of dinucleotides following the mixing RNA polymerase and DNA at two polymerase concentrations differing by a factor of two.

Overall, the synthesis of the short polynucleotides should begin sooner when polymerase is provided at a higher concentration.

By varying the concentration of polymerase in a set of experiments and appropriately plotting the results, we can extrapolate to determine the results that would have been seen if polymerase had been added at infinite concentration. In such a situation, the delay of polymerase binding to promoter should be zero. The residual delay in the appearance of polynucleotides is the time required for isomerization of the polymerase and DNA to the active state. Knowing this, we can then work back and determine the rate of binding of RNA polymerase to the promoter.

Consider now the possibility that the initial binding of RNA polymerase to promoters is fast and that the conversion of the bound polymerase to the active state is slow. If only a fraction of the promoters are occupied by RNA polymerase. Increasing the concentration of RNA polymerase in this situation will also increase the rate of the initial appearance of the polynucleotides. The reason is that the initial concentration of polymerase in the bound state increases with increasing concentrations of polymerase in the reaction. The polynucleotide assay permits quantitation of the apparent binding constant and of the isomerization rate for this situation as well. Most importantly, the assay may also be used to determine how an auxiliary protein assists initiation on some promoters.

مواضيع ذات صلة

Involvement of the U1 snRNP Particle in Splicing

البادئ (Promoter)

تضاعف الدنا

The Clinical Utility of Genomics in Hematologic Malignancies

The Discovery and Assay of RNA Splicing

Termination

Polymerase Elongation Rate

فائدة القفازات

الحلزون المزدوج للدنا

تركيب الدنا

Melted DNA Under RNA Polymerase

Structural Variation